DRIVE RODS
			The drive rod is produced from heat treated steel bar. The drive end is machined to fit into earth anchors in the 'Stealth' range. The drive head is available in two designs suitable for either hand or powered installation.
			HAND DRIVE RODS
			The drive head is rounded for installation using a postrammer or sledgehammer. Hand drive rods are available in the following sizes:-
			POWER DRIVE RODS
			The drive head is shanked to fit a percussive breaker. Power drive rods are available in the following configurations:-
			MULTI-PIECE DRIVE ROD SET
			A multi-piece drive rod set is specified when an earth anchor installation exceeds the depth of a single drive rod. Consisting of a drive end, a number of rod sections including integral couplers, and a shank. Standard sets range from 3 - 10 metres and can be used with light, medium and heavy percussive installations.
			POWER PACK AND BREAKERS
			The power pack is used to power the hydraulic percussive breakers and loadlocking units. It has an output of 30 lpm (8gpm) and a pressure rating of 2000 psi (140 bar). Any reduction in these values will notably inhibit performance. The correct choice of breaker will depend on the size of earth anchor and ground conditions. A 20-25kg breaker is usually adequate to install Stealth anchors, while a 35-40kg breaker is normally required to install Bat anchors. The efficiency of the power pack and breaker will determine the installation time of an anchor system.

			Platipus Anchors Limited - UK Office Kingsfield Business Centre, Philanthropic Road, REDHILL, Surrey, RH1 4DP, England. Tel:  +44 (0) 1737 762300  Fax: +44 (0) 1737 773395  Email:  info@platipus-anchors.com
			Platipus Anchors Inc - USA Office 2008 Garner Station Boulevard, Raleigh, NC 27603, USA. Tel:  866 PLATIPUS (752 8478)  Fax: 919 859 9597  Email:  info@platipus-anchors.com