Print Engineering Brochure
HEAVY PERCUSSIVE INSTALLATION
PRINT THIS PAGE
PRINT BROCHURE
The B8 and B10 earth anchors are normally associated with heavy percussive installation. In this situation, installation is completed using a wheeled or tracked excavator with a percussive breaker attachment. Loadlocking is completed using a larger manual hydraulic stressing kit providing proof loads up to 200kN.

Where ground conditions are hard or large quantities of earth anchors are to be installed this type of equipment can also used to install the S10, B4 and B6 anchors.

Contact Us

ENQUIRY FORM

Download Acrobat Reader
Download it Here
Site Map
DOWNLOAD FLASH
PLAYER HERE





 
   
 
 
 
 

 

 
STAGE ONE - DRIVING THE EARTH ANCHOR
Drive the earth anchor system into the ground to the required installation depth.
 
STAGE TWO - REMOVING THE RODS
Remove the drive rod from the body of the earth anchor, either by hand or using rod removing equipment.
 
STAGE THREE - LOADLOCKING
Loadlock the earth anchor system into its working position by applying a load to the wire tendon.

spacer spacer
spacer spacer
spacerspacer UK - Office address address Platipus Anchors Limited - UK Office Kingsfield Business Centre, Philanthropic Road, REDHILL, Surrey, RH1 4DP, England.
Tel:  +44 (0) 1737 762300  Fax: +44 (0) 1737 773395  Email:  info@platipus-anchors.com
spacer
spacerpixel
spacer
spacer spacer spacer Platipus Anchors Inc - USA Office 2008 Garner Station Boulevard, Raleigh, NC 27603, USA.
Tel:  866 PLATIPUS (752 8478)  Fax: 919 859 9597  Email:  info@platipus-anchors.com
spacerspacer